Peblar Home

Peblar Home weighs just 2.9kg and is installed on the wall or on a pole by a certified installer in a single visit. The entire system sits on one integrated printed circuit board, with a limited amount of cables and elements, so there is less to connect and less that can go wrong.

Commissioning happens through the local web interface over WiFi or ethernet, where your installer sets the power limit, the load balancing method and the solar mode in a few steps. Once it is on the wall, it is ready to charge.

Peblar Home works with the energy you already have. Dynamic load balancing reads your home's consumption through a P1 meter, CT coils or a Modbus meter and adjusts the charging power in real time, so you can charge at full speed without upgrading your grid connection.

Scheduled charging lets you charge when energy is cheapest, and the local web interface shows real-time and historical charging sessions so you always know what your EV has used.

Peblar Home connects over WiFi or ethernet and supports OCPP 1.6-J, so it can be linked to a back office or energy management platform of your choice, or simply managed from the web interface on your own network. Firmware updates arrive remotely, so the charger keeps improving after installation.

Our chargers are built to integrate with the most common back offices and home energy systems in the market, and the hardware is ready for the future of connectivity.

Designed, tested and manufactured in the Netherlands, Peblar Home is built to last. Every charger is tested end of line before it leaves the factory, and the IP54 rated housing handles rain, frost and heat from -30 to +50 degrees Celsius.

Security does not stop at the hardware. Our chargers only allow encrypted web sockets, meet all safety requirements and regulations, and our software is tested every day. The result is a field failure rate of 0.1% across 100,000+ deployed chargers, a 0.01% dead-on-arrival rate and 100% end-of-line testing.